Duck
Sarcastic remark goes here
That's basically what I'm piecing together except with a 90 instead of a 45, and I'm using three of the 3 footers.
That's basically what I'm piecing together except with a 90 instead of a 45, and I'm using three of the 3 footers.
Why would @Blood be on the floor?Blood has a thread called "Blood on the Saddle". Duck should change this thread to "Blood on the Floor"

The fumes are getting to @Duck. He's using cromulent words.I embiggened the inside part of the wall thimble.
View attachment 37704
And moved the heater 9 inches south and one inch higher. I didn't like the spot the flue was aiming at. Wouldn't have left me much room to make the oversize thimble.
And finished the LP conversion.
And some other crap I can't remember cuz I'm tired.



You should hurry up and get the man cave done. You'll need a place to go when the Mrs starts acting all

looking goodGalvanic and Corrosion Compatibility Dissimilar Metal Corrosion - Engineers Edge
I've got stainless steel pipe going through a galvanized wall thimble.
Shouldn't be a problem but I guess I'll hook up a ground wire just for the hell of it. There's a junction box right next to the heater with a ground in it so grounding the sheet metal really is as simple as hooking up a 6 inch jumper wire with a ring terminal.



Well I've got stainless steel screws in galvanized sheet metal, with galvanized nuts. The hot pipe carrying the exhaust is stainless steel and will loosely fit through the hole in the wall thimble.At least a dozen inappropriate jokes here.
Carry on...
![]()




Yeah.This is turning out to be a real pain in the ass

Yeah.
First and last heater I ever install.![]()

Well I've got stainless steel screws in galvanized sheet metal, with galvanized nuts. The hot pipe carrying the exhaust is stainless steel and will loosely fit through the hole in the wall thimble.
Outside the pipe will turn 90° north and run about 6 feet horizontal. Near the end I'm going to support it with a couple of sticks of galvanized electrical conduit and a galvanized steel pipe clamp.
View attachment 37723
For the corrosion to occur they need to be in an electrically conducive path, and a path which the metal ions can flow from the more anodic metal to the more cathodic metal.
I don't know if that means electricity actually has to flow through it or what.
The heater is grounded. Or it will be as soon as I hook up the wires in the panel.
Probably not a problem. Unless static electricity can occur.
This is usually where @Hammer166 weighs in, and then @ironpony comes by afterwards and says the same thing in different words, after consulting his thesaurus.![]()
watch the damm thing not work after it's all hooked upThis is turning out to be a real pain in the ass
