Found out flue termination can't be within 4 ft of any door. National code.
Also required to be in class 3 pipe which is that single wall stainless.
Clearance to combustibles is 6".
Gonna have to exit over the door, continue out one foot, turn north and go 6 feet, maintaining an upwards slope 1/4" per foot.
Condensation drain is required because cold air on the outside of the single wall duct will cause condensation.
No idea if that drain needs a real actual drain but after the U-trap I'm just going to run it into a bucket.
Heater adapter, drain, 3' pipe, sheet metal for interior wall, thimble, 8 ft pressure treated 4x4 fence post to make a modified version of the Skateboard thing, 90° elbow, two more 3 foot straights, termination tee, tube of high temp silicone.
30+50+50+forgot what thimble costs+whatever the 4x4 costs, +30+55+50+50+50+12
Plus some kind of hardware for holding the end of the flue up.
Going north inside the shop instead of outside will require two elbows instead of one, and require redoing the gas line.
This is going to cost more than the heater itself.