Mount the blade backwards & warm it with a torch to cut plexi or plastic.
No ****.
lmao
Mount the blade backwards & warm it with a torch to cut plexi or plastic.
No ****.
You can cut sheet metal that way.lmao
No I'm just going to chew some gum and use it as adhesive.You going to hold it in place with standard window glass push pins then caulk?
I had a window glazed with that one time. The heat/cold cycles would cause it to bow in and out well over 1/8" - impossible to keep sealed. It allowed in a major draft. Couldn't wait to get rid of that crap.Yeah.
I'm using "clear acrylic sheet".
Same **** I think.
And I'm going to try cutting it with the circular saw like plywood.![]()
i was able to cut plexiglass with a razor knife, much like that is used for wall boards. i had to score the line several times, (using a T square), then after it breaks on the line. then i lightly sanded the edges with about 120 grit sand paper. a saw if not the correct tooth per inch will make shrapnel outta that stuff. not to mention, it'll crack it.Yeah.
I'm using "clear acrylic sheet".
Same **** I think.
And I'm going to try cutting it with the circular saw like plywood.![]()
no it's 70 outi'm not drunk
![]()
The trick with plastic windows is to use 1/4" or 3/8" trim to hold it on both sides. It's not bowing anywhere that way, and you have a nice deep seal channel.I had a window glazed with that one time. The heat/cold cycles would cause it to bow in and out well over 1/8" - impossible to keep sealed. It allowed in a major draft. Couldn't wait to get rid of that crap.
How big were the panes?I had a window glazed with that one time. The heat/cold cycles would cause it to bow in and out well over 1/8" - impossible to keep sealed. It allowed in a major draft. Couldn't wait to get rid of that crap.
I'm just going cut slots into the 2x6 inner frame. Assemble 3 sides, slide the plexiglass in, then put the top part on & both panes are locked on place.The trick with plastic windows is to use 1/4" or 3/8" trim to hold it on both sides. It's not bowing anywhere that way, and you have a nice deep seal channel.

In South East Asia they were pullin' on the parkas at 70°.You're in Commiefornia, by 50 degrees everyone is in parkas!

That is what I did when my Mom had her hip surgery and @Duck suggested putting cut fence posts under the coach legs to make it higher.Oh, and Menard's most likely has a cutting table. Most of the home improvement places here do. They can cut your plexi to whatever measurements you want in a lot less time than you can. And if they break it or cut it wrong, they eat the cost instead of you.
I ran POV's to Cali and back one winter. It'd be 60 in February and I'd be in shorts and tee, loving every minute of it. People looked at me like I was a Martian or something.In South East Asia they were pullin' on the parkas at 70°.
![]()