Duck Pond Redneckery


But there's 4 buses & 4 straps coming in from the panels. :confused-96:
Couple thoughts....
Are there any other connections you can see?

Do the output wires hook to the buses, or go elsewhere?

They way those diodes are orientated, all the buses should be the same polarity. Did you measure across the output wires? Was it the same 28 volts? Something isn't adding up!
 
Couple thoughts....
Are there any other connections you can see?

Do the output wires hook to the buses, or go elsewhere?

They way those diodes are orientated, all the buses should be the same polarity. Did you measure across the output wires? Was it the same 28 volts? Something isn't adding up!
The voltage across the output wires was the same as measuring from bus 1 & 4.

At the bottom of each bus there's a little hole. The output wires have prongs that plug into those holes. If it wasn't for the bottom of the box only having holes below 1 & 4, the output wires could be connected to 2 or 3.

I don't know why there are two diodes in each set because they're tied together at each side by the buses they connect to. I mean I don't know why there would be two parallel diodes wired in a way in which only one would be needed unless they're too small to handle the current flow.
 
Did anyone ever wonder how the **** he could make a phone with two coconuts and winding from the jet motor on the S S Minnow and not be able to make a simple damn sail boat?
Gettin' rescued would end the program... can't have that and stay employed ya know!
 
Here's some reading for you @Duck : http://www.digikey.com/en/articles/...mprove-solar-panel-efficiency-and-performance

I still think this is how your internal wiring is set up:

article-2012december-active-bypass-diodes-improve-fig2.jpg
 
Here's some reading for you @Duck : http://www.digikey.com/en/articles/...mprove-solar-panel-efficiency-and-performance

I still think this is how your internal wiring is set up:

article-2012december-active-bypass-diodes-improve-fig2.jpg
Yep. I bet you're right.

And the purpose of the bypass diodes is to increase efficiency by not letting shaded or damaged cells bring down the whole thing.

I think it's best to just leave them alone and use them with two batteries, and get a 24 volt trolling motor.

Or another one identical to my 12 volt one, but that would be a pain in the ass. I'd have to make an additional transom that can flip both motors out of the water simultaneously, and rig up cable steering to when I turn one, the other turns with it and space them far enough apart the props don't hit their twin's motor housing in a sharp turn. And a pedal switch that can turn them both off at the same time. Screw that.
 
Yep. I bet you're right.

And the purpose of the bypass diodes is to increase efficiency by not letting shaded or damaged cells bring down the whole thing.

I think it's best to just leave them alone and use them with two batteries, and get a 24 volt trolling motor.

Or another one identical to my 12 volt one, but that would be a pain in the ass. I'd have to make an additional transom that can flip both motors out of the water simultaneously, and rig up cable steering to when I turn one, the other turns with it and space them far enough apart the props don't hit their twin's motor housing in a sharp turn. And a pedal switch that can turn them both off at the same time. Screw that.
Have to buy a counter turning one as well or fight prop steer.
 
Yep. I bet you're right.

And the purpose of the bypass diodes is to increase efficiency by not letting shaded or damaged cells bring down the whole thing.

I think it's best to just leave them alone and use them with two batteries, and get a 24 volt trolling motor.

Or another one identical to my 12 volt one, but that would be a pain in the ass. I'd have to make an additional transom that can flip both motors out of the water simultaneously, and rig up cable steering to when I turn one, the other turns with it and space them far enough apart the props don't hit their twin's motor housing in a sharp turn. And a pedal switch that can turn them both off at the same time. Screw that.
07-jpg.36122


Before you go rigging up two batteries, tap off it where you have the probes in this pic and hook it to a load and see where the voltage is. It may be low enough to deal without cooking the batteries.
 
Have to buy a counter turning one as well or fight prop steer.
It's a raft, with almost no keel effect at all.

It steers like a barge. To make a 90° turn on a lake (non-moving water) I have to actually make a 135° turn & hold that angle a few seconds to counter the momentum from my previous trajectory, then straighten out.

I don't think prop steer will matter much. ;)

I'm leaning towards a 24 volt trolling motor though.
 
Looking at that wholesale solar site.

Looks like the dollar per watt ratio goes way up when the voltage goes down.

:confused-96:

12 volt panels are more expensive per watt. Significantly.

I wonder if that's because of the technology or because they simply produce more of the higher voltage models. Nobody buys a whole pallet of 12 volt panels, they buy one or two for an RV.

The higher voltage models are usually sold by the pallet for big arrays like @Blood's. They probably only sell them individually as replacements when they get damaged.


It's not a problem bringing two marine batteries though. I always do anyway because it's an eight mile river trip, and pushing a 1300 lb barge at 3 mph tops including drift, 40 amps, that's almost 3 hours. With the stereo going, I'll call it 3 x 40 amps, so 120 amp hours.

Each of my batteries are 120 amp hours. You're not supposed to discharge them below 50% state of charge. So that's why I have two.
 
According to Weatherbug, it looks like Wednesday or Thursday I might have some daylight to work with.

weatherbug.webp
 
Last edited by a moderator:
I haven't started my car in like a month.

Been driving my ranger around illegally with no insurance. And plates that expired in 2014.

Only because I went to move it while I was mowing & it didn't want to start.

Old shitty gas.

And it was on E.

So I finally got it started & went & filled it & put in two bottles of fuel system cleaner. Been driving it to run out that tank of gas and clean out the system.


Anyway I got in my car and there's a fucking spider web on the dash. Like a cocoon actually.

Fucking creepy.
 

Back
Top