Blood
Driveler Emeritus
Ya, get that one. I have enough parts to make you one but for $29 bucks, screw that!
You rich bastards are all alike!!

We're trying to save 4 bucks here you arrogant prick!!

Ya, get that one. I have enough parts to make you one but for $29 bucks, screw that!


You rich bastards are all alike!!
We're trying to save 4 bucks here you arrogant prick!!
![]()
Ha ha ha ha


I don't know if that will work. When the AC power is turned off, because of some stupid computer crap, it won't turn on unless the thermostat is turned on AFTER the AC power is restored. If the thermostat is telling it to fire up when the power comes back on, it goes into some stupid safety mode. It's stupid.If your thermostat will hold the program on a separate circuit or battery power the simplest solution that I know would be a simple farmers add-on outlet that powers on at just above freezing and powers off around 40 degrees.
Just run your thermostat 'always on' and plug the heater into the freeze protect outlet.
10 bucks at that farm store down the road...
K.I.S.S.
LINK
If it's a coil, it's not bi-metallic. Doesn't need to be, anyway. All it has to do is expand in length and it'll rotate itself. The inside is held still, so as it lengthens, the outer end rotates around the axis.I think that's the old school way. It's called a bimetalic coil. Same as an old car used to set the choke in a carb. In my day the contact was made with a little like light bulb filled with mercury. When it tipped over it made contact with 2 wires.
I don't know if that will work. When the AC power is turned off, because of some stupid computer crap, it won't turn on unless the thermostat is turned on AFTER the AC power is restored. If the thermostat is telling it to fire up when the power comes back on, it goes into some stupid safety mode. It's stupid.
I think mercury is something that's absorbed through the skin. Can't remember. Can kill you pretty quick if you get it inside you




Run by Columbia City IN on US30 west of Ft Wayne sometime.I'm surprised steel mills don't take advantage of all the heat they are just pissing away. Maybe new ones being built would but I don't think anyone builds a new mill. They just buy existing ones and add on.
Electronic temperature controllers are pretty simple suckers, and y'all don't need no stinkin' microprocessor ta do it.
If it's electronic, the temperature sensing element is based on the thermal characteristics of a reverse biased pn junction. A diode that's turned off - a 1N914 would do as well as anything. It has a nice linear voltage vs temperature characteristic. Hook that to whatever you're using for a controller, and voila!
Simplest and cheapest is an op-amp like an LM741 connected as a voltage comparator. Diode goes in the negative input, and a potentiometer for your temperature set point in the other. Use a Sharpie and a file card to set the temp points... 10° increments is close enough. Output runs an el-cheapo power transistor like a 2N3904... use that to run the relay that turns the heater on/off. Done. Maybe $5 total. Less if you have a well stocked junk box.
Which is pretty much what a technogeek is gonna do with a computer. And a whole buncha C gobbletygook code. And a digital display. And a plastic project box. And a power supply. We're talking $50 or so, depending on how fancy the digital display gets. Oh, and a penny for that diode.
