This thing was my grandpa's.
It's not compound. It can miter (rotate on vertical axis) but not bevel (tilt on horizontal axis).
It's cross-cut ability is just shy of 5 inches. Therefore it takes two attempts to get through a 2x6.
To greatly speed up the process of framing out 2x6 exterior walls, I convinced my dad we needed this:
It's a compound sliding miter saw. Because of the sliding action, it's cross-cut ability is 12".
Ok,... that was yesterday.
My dad just came in here and bitched because I was using my handheld circular saw to cut plywood.
Example, that strip closing off the top shelf here. . . . that's 12" by 98-3/4". That's what I was using the circular saw for.
Last night I was up on that top rack trying to get an 8 foot 2x2 furring strip to lie flat along the front edge of the shelf to have something to screw the plywood to at the bottom.
It wouldn't fit so I handed it down to him and told him to trim about a blade width off of one end.
He walked over to the table saw instead of the miter saw.
The man has TWO bachelor's degrees and a PhD.
