Duck Pond Redneckery


Turns out 15' was exactly the length I needed. :rolleyes:

Anyway the furnace is done.

Well,...

20161218_200615.webp

I don't see any reason to hook up the thermostat until the walls are done. But I need the ability to turn it on and off.

Touch the green wire to the red one and the fan comes on.

My air compressor is currently draining. It's right beside where the gas is going to enter the building and it's cheap crappy tank drain valve constantly leaks just enough to hear it. I figure it will drive the gas company guy nuts when he's testing the gas plumbing for leaks. ;)

Tomorrow I'll plow the lawn in case he decides to go ahead and trench it. He said if the ground is frozen he'll put a rubber hose across the surface until spring.

That's probably the last thing I want to chop up with the snowblower. :stare1:
 
Ok now I'm in trouble.

Sarah was on the phone with her mom and had her on speakerphone so I could share in the amusement because she's nuts and was flying high on Prozac or something and all emotional saying how much she lives everybody and everything...

She mentioned the birthday party they're having tomorrow for her grandpa who died a few weeks ago.

I said "how in the fuck is he supposed to blow out the candles?"


Apparently she didn't think that was funny. :(
 
Right now at the 4 way intersection of US 45 and "Wilmington-Peotone Road" between Wilmington and Peotone, IL (they're so clever with these street names) traffic in all 4 approaches is backed up about half a mile on W-P Road and about 2 miles on Rt 45.

I was on WP road approaching the mess eastbound. The end of the line was right at the end of someone's driveway.

All I could see from half a mile back was a Swift truck stopped at the intersection facing north on 45 and I could tell it was parked on the shoulder because police were directing traffic around it.

Maybe Swift was a witness, maybe he wasn't at fault.

Or maybe he didn't notice the flashing red light which can be seen from 2 miles away and he plowed into stopped cars.

Who knows? I didn't get any closer because I used that driveway to turn around, backtrack and take an unplowed gravel road to detour around it.

But I'm going to blame Swift anyway, because it was Swift.
 
I just plowed snow.

I'm going to need to add a page to the 1946 Ford tractor operators manual:

How to start this 70 year old machine when it's below zero....


1. Don't even bother hitting the starter even if the 6 volt battery is brand new. Just dump 180 amps into it with the booster. It'll only accept maybe 30 amps anyway.. Until to you hit the starter.

2. While it's quick-charging, put a 125,000 BTU torpedo heater two feet from the engine block, on the carburetor side.

Wait ten minutes.

3. Half throttle, full choke, step on the clutch, key on, hold down the on the starter button & wiggle the shifter lever until it figures out it's in neutral...

Exactly three seconds after ignition, no sooner, no later, reduce choke to 2/3rds.

Make sure PTO is disengaged, then carefully let go of the clutch.

Get off and move torpedo heater so it blows in between the loader bucket and the front of the tractor so the fan that runs full time, draws warm air through the radiator. Make sure the pump for the loader hydraulics is also getting blasted with heat.

As soon as loader begins to work, run it up and down continuously to circulate the frozen hydraulic oil through the super hot pump to thaw out the whole system.

Then engage PTO.

Ten minutes later when the grader blade eventually lifts off the ground, move torpedo heater around to the rear and point it underneath the rear axle to warm the sump for the shared transmission/PTO/differential oil. When you see smoke coming from the oil and grease on the bottom of the machine, move torpedo heater back to the front. Raise loader up, and position heater to blow directly into the "cooling" fan. Periodically remove a glove and check the cylinder head for heat. If it's too hot to touch, you can put cardboard over the front of the grille and operate the tractor for ten minutes.

After ten minutes or when loader hydraulics quit working, whichever comes first, bring tractor back by the heater and warm up the pump again. If cylinder head has cooled back down, as soon as loader starts functioning again, raise it up so you can remove the cardboard and point the heater directly into the radiator until engine reaches normal operating temperature again.

2 cups of kerosene in the hydraulic system will extend the time between system warm-ups by about 20 minutes.
​
 

Back
Top