No you dingbat, I was the one who DID the plowing.
![]()

No you dingbat, I was the one who DID the plowing.
![]()


) and if that's not good enough for the HVAC dick heads I'll just run flex out the wall and surround it with "fireblock" Great Stuff. 
The ductwork pieces they have at Menard's the ones that don't cost $50 per foot, don't seal up anywhere close to airtight but nothing I've found online mentions anything about needing a 5 gallon bucket of high temperature sealant.I'm confused. The only thing your missing is running the exhaust outside? That would take me 1/2 an hour. What's your problem?!?!?
Huh?You could get a thick piece of something, even wood maybe 1'x1'. Cut it in half. On each half make a kerf cut on the side. One of them make it deeper. Make a normal kerf cut on the bottom of both pieces. Make a deep kerf cut on the top of both. Make a hole in the middle for a section of Metalbestos then run your exhaust through that.

They should sell a double walled sleeve to pipe through a wall. Like they have for stoves.

I'm just going to run a flexible gas line across the yard, do the hookup myself with a 40 dollar regulator from Menard's...

Single wall through a 5 gallon bucket.
WTF is wrong with rich people?
![]()

That's what they call a "wall thimble".They should sell a double walled sleeve to pipe through a wall. Like they have for stoves.


Ok, here is half the block of wood. The blue pen marks are the dado depth on the side and the top. They are there so you can first lift the board up enough so you can get the bottom part in. The top dado is a lot deeper then the bottom. The side dado is deep also so you can slide it way to the left so you have room to get the right side in. Then close the doors and screw some metal whatever to hold it shut. Caulk on the outside. Through the hole put a small section of Metalbestos. If you don't know what that is look it up. Put your standard pie plate cover on both sides.
You can use 2" x 12" boards. Screw 2 together to make it thick enough or 3. Whatever you need. The dado has to be big enough as the thickness of your corrugated siding.
It's simple and will work and look good.
View attachment 37678
