





Also no idea how to seal it where it exits the steel siding. I'm not going to just make a big ugly glob of expanding foam.
The ugly blobs of foam I've got now are going to be inside the wall when it's done. None of it will be visible.Why? In the last pic you have a big ugly blob of foam! I'm pretty sure you don't need an air tight seal with propane or natural gas. There is very little dangerous exhaust coming out. I think all the seams work out in the correct way so it's not blowing out in between the joints.



After swapping the orifices I have to hook up a "manometer"... sounds like a Peter Meter or something...![]()
The shape doesn't matter as long as constant. The "U" makes measuring hella easier, though.Oh, and the propane conversion kit isn't just smaller burner orifices.
After swapping the orifices I have to hook up a "manometer"... sounds like a Peter Meter or something...
Gotta change the gas pressure.
In the drawing it looks like it's just a clear tube leading into a U shape. Like a sink trap.
**** it here's a picture.
View attachment 37636
It looks simple enough. I could make one easily, just gotta tape it to something that'll hold it in shape so it's accurate.

If I had to guess I'd say it's because of the higher density of propane and the smaller orifices it has to be pushed through.The shape doesn't matter as long as constant. The "U" makes measuring hella easier, though.
Now the important question: Why higher pressure for LP?
"Anyone... anyone... Bueller?"![]()
Friggin' Euro-brat! This is 'Murica!In the lab flow is expressed in Liters
Friggin' Euro-brat! This is 'Murica!
That inherent damping is a useful tool. A bank of manometers is the cheapest and easiest way to set up something for syncing carbs. You don't have the needle valves needed to stabilize the gauge due to the pressure fluctuations. Gauges don't take kindly to rapid, undamped pressure pulses.Ever wonder why pressure is commonly expressed in units of "inches of Mercury?"
Hydrostatic gauges (such as the mercury column manometer) compare pressure to the hydrostatic force per unit area at the base of a column of fluid. Hydrostatic gauge measurements are independent of the type of gas being measured, and can be designed to have a very linear calibration. They have poor dynamic response.







Got 8" today.
Of snow, you sick bastards. 8" of SNOW.![]()

not only did you get 8 inches of snow but you got plowed toWinter has arrived at the Duck Pond.
Got 8" today.
Of snow, you sick bastards. 8" of SNOW.
Fortunately my 70 year old Ford product didn't give me much trouble starting up. Just needed to dump a few extra volts into the 6V starter.
View attachment 37655
Yes I plowed part of the lawn.
Gotta move those two trailers to bury the gas line. And strangely, the only thing with a ball hitch that I own or have access to that will get the traction to move them is my ATV.
But only if the snow was below the skid plates, otherwise the ATV becomes a useless sled.



No you dingbat, I was the one who DID the plowing.not only did you get 8 inches of snow but you got plowed to![]()

