Duck Pond Redneckery


Old rusty cast iron cookware I forgot I had.

I wire wheeled em down to bare metal and am seasoning them.

Coat them with veggie oil and bake for an hour at 400°, they say...., ok,...

Well here's the finished products, still hot.

20160802_033503.webp

And here's a smoke detector with its battery removed. o_O

20160802_033521.webp

And this... :rolleyes:

20160802_033532.webp

And of course, to keep the smoke alarms upstairs from going off, there's the old redneck attic van.

20160802_034610.webp
 
I now present to the world my latest art piece which I call:

"Goldwing kickstand keeper from sinking into the ground when parked in grass platform".

20160803_202923.webp

Going to put a little dog leash on it and spray it bright orange when it cools down, so The Geezer is less likely to forget to put it back in the bike's front fairing storage compartment.

I don't think I have to explain why there is a need for such a device. ;)

The leash will be so he can pick it up off the ground while sitting on the bike.

The bolts welded to the top is to keep the kickstand from sliding off. I did the welds with my cutting torch & a coat hanger because I couldn't find my larger torch tips. :D
 
I can't figure this out..

This is what I used for primer:

20160805_225549.webp

It dried overnight, then I sprayed this on it:

20160805_225514.webp

And this is after the third coat.

20160805_225451.webp

WTF? Those lightning bolts keep appearing in the same spots. The paint shrinks somehow.

:dunno:

20160805_231644~2.webp
 
Ok my dad just walked in the barn a few minutes ago and now he was sitting in one of my orange chairs tapping his feet to THIS:



Then when it was over he told me to play it again.

LMAO. :rolllaugh:
 
Bicycle spokes:

20160806_000923.webp

The ultimate redneck welding rods.

Ten times better than coat hangers & 100 times better than baling wire.

It's high tensile steel. Been using them for years.

The go kart roll cage I made when I was 15 that protected my friend when he barrel rolled into a bulldozer at 40 mph, saving his life so he could grow up to be a heroin addict,... I did all those welds with bicycle spokes. ;)

In hindsight I should've used baling wire. In 2008 he voted for Obama. :mad:
 
I now present to the world my latest art piece which I call:

"Goldwing kickstand keeper from sinking into the ground when parked in grass platform".

View attachment 35822

Going to put a little dog leash on it and spray it bright orange when it cools down, so The Geezer is less likely to forget to put it back in the bike's front fairing storage compartment.

I don't think I have to explain why there is a need for such a device. ;)

The leash will be so he can pick it up off the ground while sitting on the bike.

The bolts welded to the top is to keep the kickstand from sliding off. I did the welds with my cutting torch & a coat hanger because I couldn't find my larger torch tips. :D

My ZX-9 had a ridiculously small foot on the kickstand, so I made something that served the same purpose. A 4" junction box cover with a shoelace tied to it. Slid right into the chest pocket of my Aerostitch.
 
My ZX-9 had a ridiculously small foot on the kickstand, so I made something that served the same purpose. A 4" junction box cover with a shoelace tied to it. Slid right into the chest pocket of my Aerostitch.
You mean you didn't use that as an excuse to try welding with a cutting torch? o_O

:D
 
I should have just sprayed the thing with plasti-dip.

And made it smaller. It doesn't have to be the size of a football field.
 
RedNecks. Always overcomplicating things.

I dug a 6"x 8"x 1 1/2" piece of cinder slab out of the yard and slapped it down where I park the bike. Took less than five minutes and no waste. In fact, it was negative waste because I repurposed somebody else's trash.

:nails:
 
RedNecks. Always overcomplicating things.

I dug a 6"x 8"x 1 1/2" piece of cinder slab out of the yard and slapped it down where I park the bike. Took less than five minutes and no waste. In fact, it was negative waste because I repurposed somebody else's trash.

:nails:
You carry that thing around in your saddle bags? o_O


Geezer strapped his fishing pole and a kite to his Goldwing & went to the park.

(He flies kites using a fishing pole.)

Parked it in the grass & 30 seconds later it fell over.

Of course, he couldn't pick it up so I had to go out there & do it. :rolleyes:
 
You carry that thing around in your saddle bags? o_O


Geezer strapped his fishing pole and a kite to his Goldwing & went to the park.

(He flies kites using a fishing pole.)

Parked it in the grass & 30 seconds later it fell over.

Of course, he couldn't pick it up so I had to go out there & do it. :rolleyes:
No. I watch where I park.
 
Then give him the riding lawnmower...or find a cheap ATV on CraigsList and tell him why it's important he have it.

:D
Judging by the way he drives his pickup, he'd flip an ATV the first time he tried to make a turn.


Seriously.


His friend Rita's riding mower quit. Her idiot son smashed into something & bent the mower deck back so the blades hit it. Coincidentally the "battery suddenly died".

So yesterday I went with the old man to load it into the pickup to bring it home & fix it.

He kept telling me that we don't need any tie downs. o_O


Well I pulled the mower back against the tailgate & strapped it to the trailer hitch so it can't roll forward.

But he didn't know I did that.

He gets in & we were on Rt 50, and as usual he waits til the last second & slams on the brakes to make a right turn.

He said "see it didn't slide".
I said "that's because I put a cargo strap on it so it wouldn't".

Back at the Duck Pond he looks at it and says "why only one strap? What's to keep the front end from slipping sideways?"

I said "well if you're not driving like a drunk teenager, you don't need anything but if you look right there, that wheel well stopped it when you took that right turn at 40 mph"

:bonk:
 
Judging by the way he drives his pickup, he'd flip an ATV the first time he tried to make a turn.


Seriously.


His friend Rita's riding mower quit. Her idiot son smashed into something & bent the mower deck back so the blades hit it. Coincidentally the "battery suddenly died".

So yesterday I went with the old man to load it into the pickup to bring it home & fix it.

He kept telling me that we don't need any tie downs. o_O


Well I pulled the mower back against the tailgate & strapped it to the trailer hitch so it can't roll forward.

But he didn't know I did that.

He gets in & we were on Rt 50, and as usual he waits til the last second & slams on the brakes to make a right turn.

He said "see it didn't slide".
I said "that's because I put a cargo strap on it so it wouldn't".

Back at the Duck Pond he looks at it and says "why only one strap? What's to keep the front end from slipping sideways?"

I said "well if you're not driving like a drunk teenager, you don't need anything but if you look right there, that wheel well stopped it when you took that right turn at 40 mph"

:bonk:
Okay. A golf cart, then. He can haul his kites around in one of those.
 

Back
Top