how is the distributor cap, and rotor.>??? is there good contact between the 2..???
have you tried cranking it over, in a dim light, to see if any spark runs down the side of the cap, (carbon tracking) or any wires bleeding the spark, to ground....>??
are the points adjusted correctly? is the condenser good..?? all these things can be the cause of a no start. is there an "electronic" ignition distributor you can get for that.>???
instead of K-1, i'd try Marvel Mystery Oil instead, in those cylinders.let it sit at least, over night.
No idea.
It sat outside for months. And most recently its been rained on for three days straight, after first being laminated in ice.
I figure I'll just winch it into the shop and see what happens today after it's dried out and been on the slow charger overnight.
Getting to the points is a pain in the ass because it's on the front between the block and the radiator. Not impossible but just enough of a pain in the ass I'm not doing it outside in the cold and rain, while kneeling in gravel and mud.
Just getting it into the shop was a project in itself.
I called the geezer to help push it thinking we could simply set strips of metal under the grader blade and push on the tops of the rear tires for a 2:1 ratio but that was pointless.
I figured "well how much force can it possibly take to roll a 3000 lb machine horizontally onto cement?" so at first, because my workbench was screwed to the wall I'd just clamp the tow strap in the vise.
Ripped the whole damn workbench off the wall.
So I had that big heavy angle iron. I cut about an 8" piece and drilled one side for lag bolts and put a half inch hole in the for something to hook to.
I knew that I'd eventually need an anchor point for winching big heavy things into the shop anyway. Gonna have to do that to get the old F-100 in there to replace its gas tank and fuel lines.
That post is directly across from the door and it's set 6 feet into the ground and surrounded with concrete. So it's perfect. And I was able to rearrange the tool boxes so it's not in the way. It fits right between my two red ones.