Duck Pond Redneckery


Imgur GIF

^That guy could probably use those fingerless gloves.
I usually don't laugh at other people's misfortunes, but..
216ee5a0a8cb118e60fbbad3961bb2be.jpg
 
20161231_183532.webp

West wall done did.

Feeling kinda sick or something. I was going to go to Menard's but I said screw it.

This will be the first New Years I'll sleep through, as far back as I can recall.
 
Is that shelf rack up against a wall on the right?
No it IS the wall on that side. It's plywooded on the back.
If yer talking about how it looks like the gray vertical leg doesn't look like it goes all the way to the ground it's just blocked from view by a narrow strip of insulation that's tossed over the shop vac.

These posts are not exactly 8 feet apart. They're 7 foot something. That means erratic stud spacing and a lot of time wasted cutting the insulation.

On the south wall, two sections are 9 ft 2 wide. So there's going to be a 14 inch wide strip of plywood in the middle or one of the ends. :mad:
 
I noticed THIS while a song by, of the hundred or so artists on that USB drive, RUSH was playing.

20161231_183504.webp

:canada:

Yeah I'll have to paint this stuff in the summer.

"Made in Canada" is the least evil of all "not made in USA" products because, well it's Canada... our little buddies up north. America Junior.

Except it also says QUEBEC. That's France Junior. :mad:

If it was made in Manitoba or Sas..katch...Sasquatch.. .whatever, that's not so bad but Quebec? LeFrogland Junior??

Yeah I gotta paint over that. :(
 
I had to make a tool for pulling the outer 2x4s inward up against the studs and holding them while I attach the brackets. I want that stuff tight, so the walls don't rattle and make noise when the wind blows.

20161230_204101.webp

The studs aren't bent, the 2x4's are.

Up until Thursday night, every time I was putting studs in, there was wind pressure on the outside, so it was helping me out.

Of course,.. I wouldn't need to make a special tool for that if the Geezer wasn't too busy arguing with stupid people in the comment sections of fake news sites. I could just feed a rope between the 2x4 and the steel at one of the ribs and have him pull inward on it.

But then when he's not needed for that, he'd be parked in a chair RIGHT in the middle of everything, getting in the way, while he trolls Newslo - Just Enough News
 
No, is the shelve against the wall to the right as in, is that room like 10' wide?
You've lost me.. :confused-96:

20161231_183532-jpg.38014


The pallet rack (red horizontal, gray vertical) is up against the north wall. In fact the north wall is attached to the pallet rack. There's like six pages full of pictures in this thread explaining how that highly unconventional wall was built, including the one @Blood decided needs YMCA as it's theme song.

The wall the camera is facing in the picture above is 24 feet from the unfinished south wall to the wall attached to the pallet rack.

The pallet rack is 44 inches front to back so the open space is just over 20 feet.

For scale, that drill press is about 5-1/2 feet tall and that cluttered workbench in the middle is 6 feet wide.
 

Back
Top