Duck Pond Redneckery


I just got done installing light fixture #7 and climbed down from the scaffold to get a light to put in it.

After grabbing a bulb out of the box, before going back up the scaffold, I turned the circuit breaker for the lights back on.

Mrs Duck pointed at the fixture I'd just installed and asked why it's not working.

:stare1:

"UM. . . MAYBE BECAUSE THERE'S NO BULB IN IT! ! ? ?"

:bonk::bonk::bonk::bonk:

20161106_180147.webp

She said "you don't have to yell. . . I'm going back in the house".

:coocoo:


Yeah I know she goes into SuperUltraTurboStupid Mode for a few hours after a few seizures but GEEZ. . . .

This officially tops "What state is Canada in?" and "have you ever driven a truck to Ireland?" as the dumbest question she's ever asked. :foreheadslap:

No not Mrs. Duck, She too fine of a lady and special too. .
Yeah, she's "special" alright. :rolleyes:
 
I just got done installing light fixture #7 and climbed down from the scaffold to get a light to put in it.

After grabbing a bulb out of the box, before going back up the scaffold, I turned the circuit breaker for the lights back on.

Mrs Duck pointed at the fixture I'd just installed and asked why it's not working.

:stare1:

"UM. . . MAYBE BECAUSE THERE'S NO BULB IN IT! ! ? ?"

:bonk::bonk::bonk::bonk:

View attachment 37228

She said "you don't have to yell. . . I'm going back in the house".

:coocoo:


Yeah I know she goes into SuperUltraTurboStupid Mode for a few hours after a few seizures but GEEZ. . . .

This officially tops "What state is Canada in?" and "have you ever driven a truck to Ireland?" as the dumbest question she's ever asked. :foreheadslap:


Yeah, she's "special" alright. :rolleyes:
Canada is in Kentuckistan

Ireland is not a bad drive. just bring extra shave cream.
 
so you'll be moving in the barn when:confused-96::D
:dunno:

Almost done with the ceiling. Then I gotta wall off the top shelf of the pallet rack & insulate it's bottom, and plug the gap around the 3 other walls and the ceiling before I can even bother with a heater.

No idea what I'm going to do for a heater. :rolleyes:
 
I have a house furnace but it's been in the chicken coop for ten years. No idea if it's any good though.
 
I have a house furnace but it's been in the chicken coop for ten years. No idea if it's any good though.
do you have drums of waste oil or transmission fluids.>??

if so, and if a waste heater is allowed by code, inquire about those.

or a wood pellet stove.>????
 
I just got done installing light fixture #7 and climbed down from the scaffold to get a light to put in it.

After grabbing a bulb out of the box, before going back up the scaffold, I turned the circuit breaker for the lights back on.

Mrs Duck pointed at the fixture I'd just installed and asked why it's not working.

:stare1:

"UM. . . MAYBE BECAUSE THERE'S NO BULB IN IT! ! ? ?"

:bonk::bonk::bonk::bonk:

View attachment 37228

She said "you don't have to yell. . . I'm going back in the house".

:coocoo:


Yeah I know she goes into SuperUltraTurboStupid Mode for a few hours after a few seizures but GEEZ. . . .

This officially tops "What state is Canada in?" and "have you ever driven a truck to Ireland?" as the dumbest question she's ever asked. :foreheadslap:


Yeah, she's "special" alright. :rolleyes:
just be lucky that mrs duck don't think that you need to call in an electrician because the light is not working:bonk::bonk::stare1::rolleyes::rolllaugh3:
 
just be lucky that mrs duck don't think that you need to call in an electrician because the light is not working:bonk::bonk::rolllaugh3:
Right after I posted that, light fixture #8 turned out to be a factory defect.

I couldn't screw a bulb into it. The plastic threads were stripped out. Actually they were too large in diameter. I removed & tossed that fixture on the floor and it shattered like glass. I tried another one and it was fucked up too.

Then I got curious & grabbed a different light bulb and it went in just fine. :rolleyes:

That's when I discovered that those LED light bulbs are damn near indestructible.

I threw it on the floor to break it because I KNOW my dad would pull it out of the trash can and put it back with the rest & cause that problem again.

Slamming it on the cement as hard as I could TWICE didn't do anything to it. So I grabbed my kinetic persuasion device and hit it & it smashed the base part but not the translucent bulb part. :confused:
 
:dunno:

Almost done with the ceiling. Then I gotta wall off the top shelf of the pallet rack & insulate it's bottom, and plug the gap around the 3 other walls and the ceiling before I can even bother with a heater.

No idea what I'm going to do for a heater. :rolleyes:
you'll need a mail box as well since more than likely you'll be spending lots of time out there:rolleyes:. what happened with the torpedo heater or do you need something that's a little more adult proof:confused-96:
 
you'll need a mail box as well since more than likely you'll be spending lots of time out there:rolleyes:. what happened with the torpedo heater or do you need something that's a little more adult proof:confused-96:
Well I have a torpedo heater that will heat it in 5 minutes but it's been abandoned in the east barn since like 2008 with kerosene in it.

I have no idea if kerosene goes bad like gasoline.

But even when the damn thing was new, it would never ignite unless I removed the top cover and held a propane torch by the spark plug when I plugged it in.

Also torpedo heaters don't burn efficiently at all until the nose cone thing is glowing orange.

So unless I wanted to gag on the unburnt kerosene fumes I had to point it out the door for a few minutes when I first turn it on.

That'll be a pain in the ass in this workshop because of the insulation. If I simply fire it up and leave it on, it'll get too hot in there after a while. Even with all the tools and high mass objects sucking heat out of the air.
 

Back
Top