Duck Pond Redneckery


Ok, this still makes no sense at all why your doing this. Your closing off an uninsulated section of your barn that's 13' tall which your going to heat. Your not going to heat it I can tell you that' Closing it off does nothing unless the walls and ceiling are insulated. Even if they were that place is still going to be freezing. You said you needed something that was 13' tall. Why? You have a standard door on the room. Not like your going to drive a semi through it let alone a riding mower with a deck attached. Are you going to be working on cell tower poles or something? As far as I can tell you've wasted a lot of time and money on nothing other then enclosing an igloo within an igloo. I can assure you from first hand experience that one of those torpedo heaters is not going to heat the place. Been there, done it on an uninsulated 16x20 garage. The only thing it accomplished was a massive headache.

Now if it were me I would have picked a corner and built maybe a 16x16x8 workshop that was insulated and had decent heat like an 8' section of electric baseboard heating. In the dead of winter when it's cold out you just can't waltz into a workshop that's -20 and turn the heat on. Same as a truck or even your house. The thermometer may say 72 inside but it's F****ing cold. Everything is just plain radiating cold cold cold. My wood shop in the basement was the same until I put fins on the hot water pipe running through the shop upstairs for the forced hot water heating of the living room. My glue didn't freeze or anything else. It was always nice and toasty in there. That shop was maybe 16x16 or 20x20, can't remember but I insulated all the walls. The ceiling was already insulated.
 
Ok, this still makes no sense at all why your doing this. Your closing off an uninsulated section of your barn that's 13' tall which your going to heat. Your not going to heat it I can tell you that' Closing it off does nothing unless the walls and ceiling are insulated. Even if they were that place is still going to be freezing. You said you needed something that was 13' tall. Why? You have a standard door on the room. Not like your going to drive a semi through it let alone a riding mower with a deck attached. Are you going to be working on cell tower poles or something? As far as I can tell you've wasted a lot of time and money on nothing other then enclosing an igloo within an igloo. I can assure you from first hand experience that one of those torpedo heaters is not going to heat the place. Been there, done it on an uninsulated 16x20 garage. The only thing it accomplished was a massive headache.

Now if it were me I would have picked a corner and built maybe a 16x16x8 workshop that was insulated and had decent heat like an 8' section of electric baseboard heating. In the dead of winter when it's cold out you just can't waltz into a workshop that's -20 and turn the heat on. Same as a truck or even your house. The thermometer may say 72 inside but it's F****ing cold. Everything is just plain radiating cold cold cold. My wood shop in the basement was the same until I put fins on the hot water pipe running through the shop upstairs for the forced hot water heating of the living room. My glue didn't freeze or anything else. It was always nice and toasty in there. That shop was maybe 16x16 or 20x20, can't remember but I insulated all the walls. The ceiling was already insulated.
the HVAC system will be another chapter:D
 
Ok, this still makes no sense at all why your doing this. Your closing off an uninsulated section of your barn that's 13' tall which your going to heat. Your not going to heat it I can tell you that' Closing it off does nothing unless the walls and ceiling are insulated. Even if they were that place is still going to be freezing. You said you needed something that was 13' tall. Why? You have a standard door on the room. Not like your going to drive a semi through it let alone a riding mower with a deck attached. Are you going to be working on cell tower poles or something? As far as I can tell you've wasted a lot of time and money on nothing other then enclosing an igloo within an igloo. I can assure you from first hand experience that one of those torpedo heaters is not going to heat the place. Been there, done it on an uninsulated 16x20 garage. The only thing it accomplished was a massive headache.

Now if it were me I would have picked a corner and built maybe a 16x16x8 workshop that was insulated and had decent heat like an 8' section of electric baseboard heating. In the dead of winter when it's cold out you just can't waltz into a workshop that's -20 and turn the heat on. Same as a truck or even your house. The thermometer may say 72 inside but it's F****ing cold. Everything is just plain radiating cold cold cold. My wood shop in the basement was the same until I put fins on the hot water pipe running through the shop upstairs for the forced hot water heating of the living room. My glue didn't freeze or anything else. It was always nice and toasty in there. That shop was maybe 16x16 or 20x20, can't remember but I insulated all the walls. The ceiling was already insulated.
20161102_014109.webp

20161101_224409.webp

20161102_014646.webp

Shaddup. :mad:
 
I have a torpedo heater that'll heat a 50×50×15 sheet metal and tube frame aircraft hangar with a canvas roof in the dead of winter. I know this cuz I've done it.

The torpedo will be for quick projects like working on the tractor in the middle of winter.

A combination of solar and a propane house furnace will keep it continuously heated for longer projects when I'm in there every day for a week or so.

At my old house the garage was 24 x 24 with no ceiling and no insulation at all, anywhere & I could get it warm in about an hour or two in the middle of winter using the old 1950's era 35k BTU direct vent NG heater.

On REALLY cold days I'd have to turn on the ceiling fan that was located right over the spot where most of the heat would rise up into the attic area.

The average temperature here in winter is about 25-30 in the daytime and teens at night.

I want the overhead space in case I ever work on a helicopter in there. I don't want to have to drag it outside in the cold to test it.
 
35k BTU is NOTHING! F***, an Espar is like 15k. Like to see that heat your garage.
Yes I know it's nothing but it did heat it. Even at night. It was the regular hangout place until I took over the shed which was smaller.

There was originally insulation in that garage but it fell down. And when we put a new roof on it one year , my dad even installed a full length ridge vent.

I shoved old bed sheets in it from underneath to block it though.

The walls had tar paper between the studs and whatever was behind the siding. I guess Tyvec wasn't invented at the time.
 
Young man, there's no need to feel down.
I said, young man, pick yourself off the ground.
I said, young man, 'cause you're in a new town
There's no need to be unhappy.

Young man, there's a place you can go.
I said, young man, when you're short on your dough.
You can stay there, and I'm sure you will find
Many ways to have a good time.

It's fun to stay at the D.U.C.K.
It's fun to stay at the D.U.C.K.
 
Crystalline Silica . . . WTF is that?

There's no MSDS with these ceiling tiles, just a warning label. Says don't snort it like coke or you'll die or something. :dunno:


Whatever though. I held a cigarette lighter to a little piece of the insulation. It turned black but that's all that happened after like 30 seconds of flame directly on it.

Then I did the same thing to a scrap of ceiling tile. Since the stupid T channels don't have the first of the 4 foot slots for the little 2 foot cross pieces right at 4 feet from the end I'm having to cut all the panels at the north end down to 43-5/8". So I took one of those scraps and held the lighter to it.

The white face immediately turned black and after about 30 seconds it started smoking a little bit but it never started burning by itself.
 
Last edited by a moderator:
Crystalline Silica . . . WTF is that?

There's no MSDS with these ceiling tiles, just a warning label. Says don't snort it like come or you'll die or something. :dunno:


Whatever though. I held a cigarette lighter to a little piece of the insulation. It turned black but that's all that happened after like 30 seconds of flame directly on it.

Then I did the same thing to a scrap of ceiling tile. Since the stupid T channels don't have the first of the 4 foot slots for the little 2 foot cross pieces right at 4 feet from the end I'm having to cut all the panels at the north end down to 43-5/8". So I took one of those scraps and held the lighter to it.

The white face immediately turned black and after about 30 seconds it started smoking a little bit but it never started burning by itself.
you can get cancer from it.

you're gonna die


after you do all that work.


then the place will be sold.

someone else will enjoy the fruits (and death) of your labor.

shoulda put a plastic vapor barrier.
 

Back
Top