Ok, he's in and I asked and yes, it's the heat. Also, I mentioned about you using copper. Is copper hooked up to the tank? If so, bad idea. Chances are the inside of the tank is zinc galvanized and the copper will cause an electrical reaction and cause particles to form and rust. He said people who do use copper use a section of non conductive pipe coming off the tank then to copper.
A little off topic but when this guy was going for his PhD part of the course was that he had to be pretty good in the machine shop. After that he had to spend 6 months in a foundry learning to cast in clay and sand then machine those parts. Thought that was interesting.
A little off topic but when this guy was going for his PhD part of the course was that he had to be pretty good in the machine shop. After that he had to spend 6 months in a foundry learning to cast in clay and sand then machine those parts. Thought that was interesting.










