Rig Master Error Codes

[Sinister]

It starts, then runs for a minute, then just as the compressor kicks in, it conks out, and the control panel goes BEEEEEEEEEEEEEEEEP....then it tells me "Error 4 - Engine Run Failure" (as if the thing dying didn't clue me into that much). It's an RCAT 14-6 near as I can tell.

I've downloaded the .pdf's and can't seem to find the answer. Or at least it's not in bright neon for a mechanical moron such as me.

So far I'm thinking this particular error code means "The wizards at the shop just serviced it this weekend."

*sigh*

Any ideas?

Also, I didn't know if this belonged in here or in Technology...

 

[saddlesore]

Sounds like a auto-shutdown, low oil/oil pressure, or a plugged fuel filter, or even a clogged air filter will do that... or it just doesn't like you.

 

[bigyellowpete]

Sounds like a auto-shutdown, low oil/oil pressure, or a plugged fuel filter, or even a clogged air filter will do that... or it just doesn't like you.

I just read through what I found here: http://www.rigmasterpower.com/UserAccess/downloads/General/RigMaster_Trouble-Shooting-Guide.pdf, Page 7, and you are on the right track for sure.

 

[Racer X 69]

Check all the fluids, the air filter, look for anything obvious that may be loose or disconnected, then cal it in to the shop and start up the main powerplant for the air conditioning.