Being as this is a four year old thread I am going to take liberty here.
We had a trailer where the valve was pissing out air. So my partner starts hammering on it as was the style with the old valves.
Broken pieces of plastic everywhere.
So I hook to the trailer and the valve is leaking and I start hammering on it. As was the style with the old valves. Broken pieces of plastic everywhere.
Had to call out a mechanic who told us don't hammer on these new valves as was the style with the old valves.
These plastic pieces of crap are expensive!
100 % is compressor !! I did the same you did and problem was the same !! So I try compressor ! There are two lines to the governor . One is to sense tank pressure . The other line is a signal line to the air dryer to tell it to purge or blow off when the tank pressure line is at 120 psi !! Good luck
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.